SC 64
단종

64 I/O 디지털 매트릭스 프로세서

SC 64
큰 이미지

dbx Zone Processing 제품의 원리에 기반한 SC 64 Digital Matrix Processor는 Digital Matrix Processing의 새로운 플래그십 제품입니다. HiQnet System Architect™를 사용한 마법사 기반 구성으로 비교할 수 없는 DSP 성능, 뛰어난 라우팅 유연성 및 풍부한 처리 도구를 최소한의 교육으로 사용할 수 있습니다. SC 64는 가장 까다로운 통합 시스템을 구축할 수 있는 기초가 되는 전문적인 선택을 나타냅니다.

SC 64는 총 64개의 아날로그 I/O를 가지며, 8개 단위의 뱅크로 구성할 수 있습니다. 섀시는 최대 8개의 아날로그 입력 및/또는 아날로그 출력 카드를 지원하여 9가지의 완전히 로드된 구성을 용이하게 합니다. 아날로그 입력 카드는 입력별 마이크/라인 스위칭 및 팬텀 파워를 통해 광범위한 소스를 수용합니다. 2개의 고속 옵션 슬롯은 향후 출시될 고대역폭 오디오 전송 I/O 카드 추가 기능을 제공합니다. 이 모든 기능은 세련된 2U 랙 섀시에 탑재되어 있습니다.

SC 64는 일반적인 처리 기능을 위한 전용 DSP 및 전문 처리를 위한 삽입 위치를 제공하여 Advanced Feedback Suppression (AFS), Ambient Noise Compensation (ANC), 우선순위 더킹, 파라메트릭 이퀄라이제이션 (PEQ), 지연 및 다이나믹스를 포함한 많은 처리 기능을 제공합니다. SC 64는 HiQnet System Architect™ 사용자 정의 제어 패널, 이더넷, 시리얼, 접점 폐쇄, 널리 사용되는 ZC 월 컨트롤러 및 자동 스케줄된 이벤트를 포함한 다양한 제어 옵션을 가지고 있습니다. 많은 제어 방식을 통해 SC 시스템은 까다로운 계약자의 필요와 기술 전문성에 맞게 진정으로 맞춤화될 수 있습니다.

권장 용도: Installed.

특징

  • 8개 뱅크로 설정 가능한 64채널 아날로그 I/O
  • 아날로그 입력 카드당 채널별 8개의 마이크/라인 및 팬텀 파워
  • 이더넷 / 시리얼 제어
  • 고속 옵션 슬롯
  • 제어 입력 및 로직 출력
  • 사전 구성된 아키텍처
  • 고급 피드백 억제(AFS™), 자동 게인 보정(AGC), 압축, 디에싱 및 노치 파라메트릭 이퀄라이제이션을 포함한 입출력 선택 가능한 DSP 삽입
  • 완전한 라우팅 유연성
  • HiQnet System Architect™에서의 포괄적인 구성, 제어 및 모니터링
  • 마법사 구성
  • 이벤트 스케줄러
  • 미디어 재생을 위한 선택 사항 미디어 엔진
  • 선택 사항 ZC 월 패널 제어

다운로드

문서
  언어 크기 업로드 날짜
file type icon SC 64 브로셔-영어
en 업데이트: 2026년 4월
en  1.06MB 2026년 4월
file type icon SC 64 CAD 파일
en 업데이트: 2026년 4월
en  710KB 2026년 4월
file type icon SC 64 컷 시트-영어
en 업데이트: 2026년 4월
en  781KB 2026년 4월
file type icon SC 64 설치 가이드-영어
en 업데이트: 2026년 4월
en  4.45MB 2026년 4월
file type icon ApplicationGuide-House-of-Worship.zip
en 업데이트: 2026년 4월
en  6.36MB 2026년 4월
file type icon ApplicationGuide-Recreation-Center.zip
en 업데이트: 2026년 4월
en  2.47MB 2026년 4월
file type icon ApplicationGuide-Restaurant-Bar.zip
en 업데이트: 2026년 4월
en  3.32MB 2026년 4월
file type icon ApplicationGuide-Retail-Store.zip
en 업데이트: 2026년 4월
en  3.16MB 2026년 4월
file type icon Retail Store with Media Engine.zip
en 업데이트: 2026년 4월
en  17.9MB 2026년 4월
file type icon SC32_SC64_Help.pdf
en 업데이트: 2026년 4월
en  22.6MB 2026년 4월
file type icon SCMediaEngineDataSheet.pdf
en 업데이트: 2026년 4월
en  614KB 2026년 4월
file type icon SC_AnalogCardsDataSheet.pdf
en 업데이트: 2026년 4월
en  589KB 2026년 4월
Training Resources
  크기 업로드 날짜
file type icon SC Navigation Essentials
업데이트: 2020년 10월
18.5MB 2020년 10월

위의 링크 중 하나에서 브라우저에 이상한 문자가 표시되면, 파일을 마우스 오른쪽 버튼으로 클릭하여 컴퓨터에 저장하세요.

사양

Indicators Per Input: Signal Present, Clip, 48V Phantom Power, SYNC, I/O card type (IN, OUT, D-IN, D-OUT)
Other Indicators LCD Display, Page Button, Select Button and LED indicators for: Global CLIP, Link/Active, RS-232 and Power
Audio Card Slots 8 Card Slots (A, B, C, D, E, F, G, H)
High Speed Option Slot 2 Card Slots
Input (8) per Input Card
Input Connectors Phoenix/Combicon, 3.5mm pitch
Input Gain Range Nominal Gain 0 dB, electronically switchable up to +48 dB, in 6 dB steps
Input Type Electronically balanced, RF filtered
Input Impedance 3.5 k ohm
Max Input +22dBu
CMRR >40 dB typical, >55 dB at 1 kHz
Mic Preamp Phantom Power +48 VDC, selectable per input
Output (8) per Output Card
Output Connectors Phoenix/Combicon, 3.5mm pitch
Output Type Electronically balanced, RF filtered
Output Impedance 44 Ω
Max Output +20 dBu
Dynamic Range 107 dB unweighted, 110 dB A-weighted
Internal Processing 32 bit floating point
THD+Noise 0.0045% typical at 0 dBu, 1 kHz, 0 dB input gain
Frequency Response 20 Hz- 20 kHz, +/-0.50 dB
Sample Rate 48kHz
GPIO Ports 8 Control Inputs and 6 Logic Outputs (Phoenix/Combicon, 3.5mm pitch)
Control Input Voltage 0 to 4.5v
Control Input Impedance 4.7 k ohm to +5V (2-wire mode)
Logic Output Voltage 0 or +5V unloaded
Logic Output Impedance 440 ohm
Logic Output Current 10mA source, 60mA sink
Relay Contact Connector Phoenix/Combicon, 3.5mm pitch
Relay Contacts Common (C), Normally Open (NO), Normally Closed (NC)
Relay Contact Rated Load 0.3A at 125VAC, 1A at 30VDC
Watchdog Output Phoenix/Combicon, 3.5mm pitch for failsafe control Opto-isolated
Watchdog Output Current 14mA maximum
Watchdog WIthstanding Voltage 80V maximum (Off)
Watchdog Series Impedance 220Ω (isolated)
Input Delay Length per channel: Up to 5120ms of input delay
Input EQ per channel: 4 Band Parametric
Input Gate per channel: Downward Expander
Input Signal Processing Two selectable Input Processing blocks per input
Insert Types Advanced Feedback Suppression, Automatic Gain Control, Compressor, De-Esser, 12-Band Notch EQ, 12-Band Parametric EQ, Sub-Harmonic Synthesizer
Ducker 24 level priority ducker
Routing/Mixing 32x1 mixer on every output zone
Output Insert Processing One selectable Output Processing block per output: Gain, Automatic Gain Control, Ambient Noise Compensation, Auto-Warmth™
Crossover configs: 1x1, 1x2, 1x3, 1x4
Crossover Filter Type Bessel 6, 12, 18 and 24 dB/Octave, Butterworth 6, 12, 18 and 24 dB/Octave, Linkwitz-Riley 12 and 24 dB/Octave
Output EQ 6 Band Parametric per channel
Limiter Type dbx PeakStopPlus™
Output Delay Length Up to 5120ms of output delay
Controls Ethernet, RS-232, Optional dbx ZC Wall Panels
Power Consumption 100V to 240VAC 50/60Hz, 120 Watts
Dimensions 3.5" (2U) x 19" x 15" (89mm x 483mm x 381mm)
Unit Weight 18.9 lbs. / 8.57 kgs. (with all audio cards installed)

교육 모듈

뉴스

지원/FAQ