| Indicators |
Per Input: Signal Present, Clip, 48V Phantom Power, SYNC, I/O card type (IN, OUT, D-IN, D-OUT) |
| Other Indicators |
LCD Display, Page Button, Select Button and LED indicators for: Global CLIP, Link/Active, RS-232 and Power |
| Audio Card Slots |
4 Card Slots (A, B, C, D) |
| High Speed Option Slot |
1 Card Slot |
| Input |
(8) per Input Card |
| Input Connectors |
Phoenix/Combicon, 3.5mm pitch |
| Input Gain Range |
Nominal Gain 0 dB, electronically switchable up to +48 dB, in 6 dB steps |
| Input Type |
Electronically balanced, RF filtered |
| Input Impedance |
3.5 k ohm |
| Max Input |
+22dBu |
| CMRR |
>40 dB typical, >55 dB at 1 kHz |
| Mic Preamp Phantom Power |
+48 VDC, selectable per input |
| Output |
(8) per Output Card |
| Output Connectors |
Phoenix/Combicon, 3.5mm pitch |
| Output Type |
Electronically balanced, RF filtered |
| Output Impedance |
44 Ω |
| Max Output |
+20 dBu |
| Dynamic Range |
107 dB unweighted, 110 dB A-weighted |
| Internal Processing |
32 bit floating point |
| THD+Noise |
0.0045% typical at 0 dBu, 1 kHz, 0 dB input gain |
| Frequency Response |
20 Hz- 20 kHz, +/-0.50 dB |
| Sample Rate |
48kHz |
| GPIO Ports |
8 Control Inputs and 6 Logic Outputs (Phoenix/Combicon, 3.5mm pitch) |
| Control Input Voltage |
0 to 4.5v |
| Control Input Impedance |
4.7 k ohm to +5V (2-wire mode) |
| Logic Output Voltage |
0 or +5V unloaded |
| Logic Output Impedance |
440 ohm |
| Logic Output Current |
10mA source, 60mA sink |
| Relay Contact Connector |
Phoenix/Combicon, 3.5mm pitch |
| Relay Contacts |
Common (C), Normally Open (NO), Normally Closed (NC) |
| Relay Contact Rated Load |
0.3A at 125VAC, 1A at 30VDC |
| Watchdog Output |
Phoenix/Combicon, 3.5mm pitch for failsafe control Opto-isolated |
| Watchdog Output Current |
14mA maximum |
| Watchdog WIthstanding Voltage |
80V maximum (Off) |
| Watchdog Series Impedance |
220Ω (isolated) |
| Input Delay Length |
per channel: Up to 5120ms of input delay |
| Input EQ |
per channel: 4 Band Parametric |
| Input Gate |
per channel: Downward Expander |
| Input Signal Processing |
Two selectable Input Processing blocks per input |
| Insert Types |
Advanced Feedback Suppression, Automatic Gain Control, Compressor, De-Esser, 12-Band Notch EQ, 12-Band Parametric EQ, Sub-Harmonic Synthesizer |
| Ducker |
24 level priority ducker |
| Routing/Mixing |
32x1 mixer on every output zone |
| Output Insert Processing |
One selectable Output Processing block per output: Gain, Automatic Gain Control, Ambient Noise Compensation, Auto-Warmth™ |
| Crossover |
configs: 1x1, 1x2, 1x3, 1x4 |
| Crossover Filter Type |
Bessel 6, 12, 18 and 24 dB/Octave, Butterworth 6, 12, 18 and 24 dB/Octave, Linkwitz-Riley 12 and 24 dB/Octave |
| Output EQ |
6 Band Parametric per channel |
| Limiter Type |
dbx PeakStopPlus™ |
| Output Delay Length |
Up to 5120ms of output delay |
| Controls |
Ethernet, RS-232, Optional dbx ZC Wall Panels |
| Power Consumption |
100V to 240V 50/60Hz, 120 Watts |
| Dimensions |
3.5" (2U) x 19" x 15" (89mm x 483mm x 381mm) |
| Unit Weight |
15.7 lbs. / 7.12 kgs. (with all audio cards installed) |
更新: 2026年4月
