| 输入接口 |
XLR and 1/4" TRS (Pin 2 and tip hot) |
| 输入的类型 |
Electronically balanced/unbalanced, RF filtered |
输入阻抗 |
Balanced > 50 kOhm, unbalanced >25 kOhm |
最大输入 |
> +24 dBu balanced or unbalanced |
| 共模 |
Typically >50 dB at 1 kHz |
| 输出连接器 |
XLR and 1/4" TRS (Pin 2 and tip hot) |
| 输出类型 |
Servo-balanced/unbalanced, RF filtered |
输出阻抗
|
Balanced 120 Ohm, unbalanced 60 Ohm |
最大输出 |
> +21 dBm balanced, > +20 dBm unbalanced |
| Sidechain 输入连接器 |
1/4" Unbalanced (Tip-Sleeve) |
| Sidechain 输入类型 |
Unbalanced, RF filtered |
| Sidechain 阻抗 |
>10 kOhm |
| Sidechain 最大输入电平 |
>+24 dBu |
| Sidechain 输出连接器 |
1/4" Balanced TRS (tip hot) |
| Sidechain 输出类型 |
Impedance balanced, RF filtered |
| Sidechain 输出阻抗 |
Balanced 2 kOhm, unbalanced 1 kOhm |
| Sidechain 最大输出电平 |
>+21 dBu balanced or unbalanced |
| 带宽 |
20 Hz to 20 kHz, +0/0.5 dB |
频率响应 |
0.35 Hz to 90 kHz, +0/-3 dB |
| 噪音 |
< -95 dBu, unweighted, 22 kHz measurement bandwidth |
| 动态范围 |
> 118dB, unweighted |
| THD + 噪音 |
0.008% typical at +4 dBu (1 kHz unity gain), 0.08% typical at +20 dBu (1 kHz unity gain), < 0.1% any amount of compression up to 40 dB, 1 kHz |
| IMD |
< 0.1% SMPTE |
| 波相声 |
< -80 dB 20Hz to 20 kHz |
| 立体声耦合 |
True RMS Power Summing |
| 压缩机的阈值范围 |
-40 dBu to +20 dBu |
| 压缩机比率 |
1:1 to infinity:1 |
| 压缩机阈值特性 |
Selectable OverEasy® or hard knee |
| 压缩机攻击/释放特性 |
AutoDynamic™ |
| 压缩机攻击/释放模式 |
Selectable Manual or Auto |
| 压缩机手动攻击时间 |
Scalable program-dependent |
| 压缩机手动发布时间 |
Scalable program-dependent |
| 压缩机自动攻击时间 |
Program-dependent |
| 压缩机自动发布时间 |
Program-dependent |
| 压缩机输出增益 |
-20 to +20 dB |
| 力矩限制器的阈值范围 |
+4 dBu to +24 dBu (off) |
| 力矩限制器的比例 |
infinity:1 |
| 限流器类型 |
PeakStopPlus® two-stage limiter |
| 限流器阶段 1 |
PeakStop® brickwall limiter |
| 限流器阶段 1 攻击时间 |
Zero |
| 限流器阶段 1 发布时间 |
Zero |
| 第二阶段力矩限制器 |
Predictive intelligent program limiter |
| 力矩限制器的第二阶段的攻击时间 |
Program-dependent |
| 力矩限制器的第二阶段发布时间 |
Program-dependent |
| 膨胀机/门的阈值范围 |
Off to +15dBu |
| 膨胀机/门比率 |
1:1 to 30:1 |
| 膨胀机/门攻击时间 |
< 100 µsec |
| 膨胀机/门发布时间 |
Program-dependent |
| SC 分机交换机 |
Routes the external sidechain input signal to the detector |
| SC 周一开关 |
Routes the sidechain signal to the output, interrupting the normal audio |
| OverEasy ® 开关 |
Activates the OverEasy compression function |
| Countour 开关 |
Activates the frequency-dependent detector function |
| 自动开关 |
Activates automatic program-dependent attack and release times, disabling the manual Attack and Release controls |
| I/O 仪表开关 |
Switches between monitoring input and output levels on the Input/Output Level meter |
| 旁路开关 |
Activates the direct input-to-output hard-wire relay bypass. Relay automatically hard-wire bypasses unit at power-down and provides a power-on delay of 1.5 sec. |
| 工作电平开关 |
(rear panel) Switches the nominal operating level between -10 dBV and +4 dBu simultaneoulsy for both input and output levels |
| ST 链接开关 |
Link both channels for stereo operation. Channel One becomes the master |
| 增益减少米 |
12-segment LED bar graph at 1, 2, 4, 6, 9, 12, 15, 18, 21, 24, 27 and 30 dB |
| I/O 计量表 |
8-segment LED bar graph at -24, -18, -12, -6, 0, +6, +12, and +18 dBu |
| 压缩机阈值米 |
3-segment LED bar graph at Below (-), OverEasy and Above (+) |
| 膨胀机/门阈值米 |
2-segment LED bar graph at Below (-) and Above (+) |
| 限流器阈值米 |
1 LED to indicate PeakStopPlus™ limiting |
| 开关功能 |
LED indicator for each front-panel switch |
| 输出变压器选项 |
Jensen® JT-123-dbx or JT-11-dbx, BCI RE-123-dbx or RE-11-dbx |
| 工作电压 |
100-120 VAC 50/60 Hz 200-240 VAC 50/60 Hz |
功耗 |
20 Watts |
| 保险丝 |
100-120 VAC:250 mA Slow Blow, 200-240 VAC:125 mA Type T |
| 电源连接器 |
IEC receptacle |
尺寸 |
1.75"Hx19"Wx9"D (4.4cmx48.3cmx20.1cm) |
单位重量 |
5.1 lbs. (2.3 kg) |
运输重量 |
7.5 lbs. (3.4 kg) |
更新: 2026年4月
也可從